Cabinet Makers, Paint and Body Workers, Assemblers, and Installers for the production lines at American Emergency Vehicles in Jefferson, North Carolina

Job Description:

Cabinet Maker III
Fabricating and installing cabinet components and hardware.
Mark outlines or dimensions of parts, according to blueprints or drawing specifications
Cutting 45-degree miters on aluminum and anodized trim
Adhering laminate to the substrate with contact adhesive
 Final assembly of parts and hardware
Assembler I
Installing and mounting nonelectrical and electrical interior/exterior components and hardware
Assemble fabricated parts, components, or other units at stations
Reading blueprint and engineering specifications
Ensure safety requirements and manufacturing quality are met
Clean and inspect the product for quality standards
Installer I
Installation of all electrical interior/exterior components and hardware
 Understand and carry out verbal and written directions in English
 Close attention to detail
Function with a minimal amount of supervision or no supervision.
Set work priorities to meet production goals as scheduled.
Assist in training installers at all skill levels.
 Establish and maintain cooperative working relationships.
 Meet minimum safety and 5S standards.
 Meet all QA and QC standards for each task.
 Be compliant with all the rules of conduct and attendance per the company handbook.
 Knows spill response procedures and evacuation routes.
Other duties and responsibilities as required.
Paint/Body
Responsible for prepping, sanding, buffing painted vehicles
 Tape and mask off nonpainted surfaces or parts around areas to be painted
 Seal body seams with epoxy seam sealer and smooth properly for final paint
 Grind, and fill with properly mixed body filler and sand to finish, all welds, dents, and gouges in
exterior panels.
Sand and shape body filler around transitions or body lines
Spray primer on all areas where body filler was applied
 Wipe down all areas to be painted with grease and wax remover
 Sand down painted surfaces to remove orange peel texture
 Operate a buffer and understand the steps required to buff paint to a proper finish
Will may be required to climb on vehicles and be required to wear fall protection
Must keep the work area safe and clean to 6S standards
 Gains or has attained full proficiency in a specific area of discipline. Works under moderate supervision